hydropeak: Detect and Characterize Sub-Daily Flow Fluctuations

An important environmental impact on running water ecosystems is caused by hydropeaking - the discontinuous release of turbine water because of peaks of energy demand. An event-based algorithm is implemented to detect flow fluctuations referring to increase events (IC) and decrease events (DC). For each event, a set of parameters related to the fluctuation intensity is calculated: maximum flow fluctuation rate mafr(), mean flow fluctuation rate mefr(), amplitude amp(), flow ratio fr(), and duration dur(). The framework is introduced in Greimel et al. (2016) "A method to detect and characterize sub-daily flow fluctuations" <doi:10.1002/hyp.10773> and can be used to identify different fluctuation types according to the potential source: e.g., sub-daily flow fluctuations caused by hydropeaking, rainfall, or snow and glacier melt.

Version: 0.1.0
Depends: R (≥ 3.5.0)
Imports: utils, parallel
Suggests: rmarkdown, knitr, testthat (≥ 3.0.0), data.table
Published: 2021-10-13
Author: Bettina Grün ORCID iD [cre, ctb], Julia Haider [aut], Franz Greimel ORCID iD [ctb]
Maintainer: Bettina Grün <Bettina.Gruen at R-project.org>
License: GPL-2
NeedsCompilation: no
Citation: hydropeak citation info
In views: Hydrology
CRAN checks: hydropeak results


Reference manual: hydropeak.pdf
Vignettes: Introduction to hydropeak


Package source: hydropeak_0.1.0.tar.gz
Windows binaries: r-devel: hydropeak_0.1.0.zip, r-release: hydropeak_0.1.0.zip, r-oldrel: not available
macOS binaries: r-release (arm64): hydropeak_0.1.0.tgz, r-release (x86_64): hydropeak_0.1.0.tgz, r-oldrel: not available


Please use the canonical form https://CRAN.R-project.org/package=hydropeak to link to this page.